This release of Ubiquity supports curtains
controlled by two (2) interlocking relays such as those controlled by
BTX/BMC and Somfy
controllers or by a single relay controlling some other type of window
covering.
Select the Windows layer of the Design Module.
|
|
Click in the location in the room in which
you plan to install the device. |
|
The "Add a Windows in the <room name>"
menu will pop up.
The "Room"
will be the room you clicked in and it cannot be changed without cancelling
out of the menu and clicking in the proper room.
Select the "Location"
based on where the device is located in the room (not were the control
for the device is located). In addition to documenting the location of
the device, the "Location" is also an auto naming feature and
it overwrites the present "Name" field.
The "Name"
must be unique in this room (but can be the same as the name in another
room). The name is auto generated by selecting the "Location"
but you can add to the auto generated name or completely delete it and
create your own name.
Check the "Controlled
by (and wired to)" check box to define how it is controlled. We highly
recommend you do this when you add the device.
The "Controlled
by" dropdown box will default to the last control used on any device
layer (note that in the example it is offering a single relay to control
this device, when most curtains require two relays). The first time you
add a device after opening the Design Module, it will default to the Relay
Control Unit of the Domain Controller.
|
|
After configuring it, the "Add a Window
in the <room name>" menu will typically look like this where:
The Location has been
entered (note that selecting multiple geographic "Locations"
leads to a compound "Name").
It is controlled by
two interlocking relays
The "Relay for
opening" defaulted to the first available relay
The "Relay for
closing" was chosen from the drop down list.
Click OK to complete adding the device. |
|