To add a Lutron CCO Relay controller, please
do the following:
|
Select
the More Ports Layer
Select the "More Ports" layer of
the Design Module. |
|
Add
the Lutron CCO Relay Controller
Note, you must have
a Homeworks Lighting System added before you can add Homeworks CCO's.
Click in the location in the room in which
you plan to add the additional ports.
|
|
You will get a pop up menu like the one at
the right.
From the "Type" dropdown box, select
"Relay Control Unit.
|
|
The menu will change to look like the one
at the right.
From the "Make" dropdown box select
"Lutron HWI CCO". |
|
Give the relay controller a name.
Enter the Processor, Link, and CCO Address
of the hardware.
Click OK
|
|
After adding the Relay Controller, a red dot
will appear where you initially clicked to add the additional ports. If
you want to change any of the parameters of that Relay Controller, click
on the red dot and make sure the "Edit Relay Controller Unit"
menu pops up. It is the one that also has a "Delete" button
on it - otherwise, you will be adding a second Relay Controller.
Now these relays are available for:
|
|