Select the Lighting Systems layer of the Design Module.
Click in the location in the room in which you plan to install the Lighting System.
You will get a pop up menu that defaults to adding the Lutron Homeworks lighting system on the 1st serial port available.
Use the "Type" dropdown box to select a different lighting system. Your choices are:
Lutron Homeworks
For the "Type", select "Lutron HWI".
You can name it whatever you want, but the default name is usually a good choice.
Select the serial port you would like to have control it.
Click OK and the system has been added.
Lutron Homeworks RF
For the "Type", select "Lutron HWI RF".
You can name it whatever you want, but the default name is usually a good choice.
Select the serial port you would like to have control it.
Click OK and the system has been added.
X.10
For the "Type", select "X10".
You can name it whatever you want, but the default name is usually a good choice.
Select the serial port you would like to have control it.
Click OK and the system has been added.
Lutron Radio RA
For the "Type", select "Radio RA".
You can name it whatever you want, but the default name is usually a good choice.
Select the serial port you would like to have control it.
Click OK and the system has been added.
Vantage
For the "Type", select "Vantage".
You can name it whatever you want, but the default name is usually a good choice.
Select the serial port you would like to have control it.
Click OK and the system has been added.
LiteTouch 5000LC
For the "Type", select "Litetouch 5000LC".
You can name it whatever you want, but the default name is usually a good choice.
Select the serial port you would like to have control it.
Click OK and the system has been added.
After clicking OK, on the menus above a red dot will appear where you initially clicked to add it. If you want to change any of the parameters of it, click on the red dot and make sure the "Edit " menu pops up. It is the one that also has a "Delete" button on it
.
